| Name |
Nachricht |
Grzegory
Adeliger
255 Beiträge
|
LAWO SICMA CONTROL e3902, 19 Jun. 2025 12:40
|
Hello everyone. I haven‘t been here for a long time. My e-mail address is not the old one, it is now a new one Contact biuro@speacetronic.pl
I have a problem with SICMA CONTROL, made by E390201D.
I will attach a few photos. It does not accept any cards. Both with data and with the new original firmware from LAWO.
After pressing two buttons inside, it enters BOOTLOADER mode, but still does not accept cards. Cards are functional, checked in another controller. I removed the flash memory and uploaded data and firmware with the ELNEC BEEPROG programmer. AM 29F800 memory. It works, sends data to the displays. But when starting it shows an error because it somehow remembers that it has a different firmware than it has in the flash memory. This is the version with time and date, if that‘s important
Geändert von Grzegory am 19.Jun.2025 13:01
|
|
| |
Beitragsbewertung:
|
Ibiwork
Bürger
72 Beiträge
|
RE: LAWO SICMA CONTROL e3902, 19 Jun. 2025 13:25
|
Did you use an Omnidrive or L1151?
If not, the current firmware doesn‘t accept your card. You‘ll need to install a new one using the devices listed above and a PC card.
|
|
| |
Beitragsbewertung:
|
Grzegory
Adeliger
255 Beiträge
|
RE: LAWO SICMA CONTROL e3902, 19 Jun. 2025 14:22
|
The card is correct. It works without any problems on another SICMA.
|
|
| |
Beitragsbewertung:
|
|
|
|
