Fien1989
Gelehrter
230 Beiträge
|
How to edit the route information of a EBIS2?, 05 Jun. 2021 01:23
|
I‘ve a Meister Electronic EBIS2 control unit with some German firmware which can send Ds009 telegrams too and has some routes pre-programmed.
The route-data and firmware is integrated into the same EPROM. I want to edit this EPROM with a own route. But how is the data stored in this EPROM?
There are only 6 selectable routes (0061, 0062, 0081, 0082, 0995 and 0999). This is stored in 8400h of the EPROM.
9400h-948Eh are the route names (24 characters per name).
9490h-9AEFh are the driver messages of the stops (showed on EBIS2).
9B10h-9F6Fh are stops with 16 characters each, but they seem to be unused.
A018h-A6A7h are the Ds009 stop texts, 24 characters each.
The stops are not sorted in the direction of the routes. So somewhere there should be a table of each route storing the stops order and also the pre-selection of the Ds1/Ds3 numbers + hPxxxx telegram numbers for I suppose an audio announcement.
I suppose (a part of) the table is stored between 8500h-9313h. But how?
Anyone knowing how to edit data of these units, eventually using a hex-editor?
If you want to take a look at the file, I can send you a .bin, just PM me 
|
|
